Recently Updated Pages
6.1.6 Step 6 — Add ball to the arsenal section
Step 6 — Add ball to the arsenal section 6.1.6 workflow Before drilling begins, Step 6 tak...
6.1.5 Step 5 — Select layout (VLS, 2LS, PAL, or manual)
Step 5 — Select layout (VLS, 2LS, PAL, or manual) 6.1.5 workflow With the bowler's grip me...
6.1.4 Step 4 — Enter thumb information (round or oval)
Step 4 — Enter thumb information (round or oval) 6.1.4 workflow With grip type and finger ...
6.1.3 Step 3 — Set grip type and enter finger measurements
Step 3 — Set grip type and enter finger measurements 6.1.3 workflow With a blank spec shee...
6.1.2 Step 2 — Create a blank spec sheet for the ball
Step 2 — Create a blank spec sheet for the ball 6.1.2 workflow With the bowler profile sav...
6.1.1 Step 1 — Create the bowler profile
Step 1 — Create the bowler profile 6.1.1 KEY workflow Drilling your first ball in Spectr...
5.7.2 Worked example: how flipping V/H changes the output numbers
Worked example: how flipping V/H changes the output numbers 5.7.2 example The previous pag...
5.7.1 Using "Flip V/H on oval cuts" to match your machine's axis
Using "Flip V/H on oval cuts" to match your machine's axis 5.7.1 calibration When Spectre ...
5.6.6 1° vs. 5° Oval Degree increments and their precision impact
1° vs. 5° Oval Degree increments and their precision impact 5.6.6 pitch When Spectre Cloud...
5.6.5 Choosing EDGE vs. CENTER: which method fits which bowler?
Choosing EDGE vs. CENTER: which method fits which bowler? 5.6.5 TIP guide With four calc...
5.6.4 CENTER with and without Add Pitch Thumb — comparison
CENTER with and without Add Pitch Thumb — comparison 5.6.4 pitch Just as the EDGE method c...
5.6.3 EDGE with and without Add Pitch Thumb — comparison
EDGE with and without Add Pitch Thumb — comparison 5.6.3 pitch When using the EDGE method ...
5.6.2 CENTER method explained — how pitch is placed at center of oval
CENTER method explained — how pitch is placed at center of oval 5.6.2 pitch The CENTER met...
5.6.1 EDGE method explained — how pitch is placed at edge of oval
EDGE method explained — how pitch is placed at edge of oval 5.6.1 pitch The EDGE method is...
5.5.3 When NONE mode is preferable (experienced fitters, custom setups)
When NONE mode is preferable (experienced fitters, custom setups) 5.5.3 oval method Spectr...
5.5.2 Using the oval cut chart to determine cuts manually
Using the oval cut chart to determine cuts manually 5.5.2 oval method When your Oval Cut D...
5.5.1 Setting up: Oval Cut Direction = NONE in Settings
Setting up: Oval Cut Direction = NONE in Settings 5.5.1 oval method Before using the Oval ...
4.3.6 Ring Finger 5/16" rule — auto and manual calculation
Ring Finger 5/16" rule — auto and manual calculation When ...
4.3.5 How to input a finger oval measurement (no inserts)
How to input a finger oval measurement (no inserts) For bowlers...
5.4.3 Entering V-only cut values and reading output
Entering V-only cut values and reading output 5.4.3 oval method With Oval Cut Direction se...