Recently Updated Pages
5.6.5 Choosing EDGE vs. CENTER: which method fits which bowler?
Choosing EDGE vs. CENTER: which method fits which bowler? 5.6.5 TIP guide With four calc...
5.6.4 CENTER with and without Add Pitch Thumb — comparison
CENTER with and without Add Pitch Thumb — comparison 5.6.4 pitch Just as the EDGE method c...
5.6.3 EDGE with and without Add Pitch Thumb — comparison
EDGE with and without Add Pitch Thumb — comparison 5.6.3 pitch When using the EDGE method ...
5.6.2 CENTER method explained — how pitch is placed at center of oval
CENTER method explained — how pitch is placed at center of oval 5.6.2 pitch The CENTER met...
5.6.1 EDGE method explained — how pitch is placed at edge of oval
EDGE method explained — how pitch is placed at edge of oval 5.6.1 pitch The EDGE method is...
5.5.3 When NONE mode is preferable (experienced fitters, custom setups)
When NONE mode is preferable (experienced fitters, custom setups) 5.5.3 oval method Spectr...
5.5.2 Using the oval cut chart to determine cuts manually
Using the oval cut chart to determine cuts manually 5.5.2 oval method When your Oval Cut D...
5.5.1 Setting up: Oval Cut Direction = NONE in Settings
Setting up: Oval Cut Direction = NONE in Settings 5.5.1 oval method Before using the Oval ...
5.4.3 Entering V-only cut values and reading output
Entering V-only cut values and reading output 5.4.3 oval method With Oval Cut Direction se...
5.4.2 When to use V-only mode
When to use V-only mode 5.4.2 oval method V-only mode is the right configuration when your...
5.4.1 Setting up: Oval Cut Direction = V in Settings
Setting up: Oval Cut Direction = V in Settings 5.4.1 CALC oval method The third Oval Cut...
5.3.4 Worked example: H-only oval
Worked example: H-only oval 5.3.4 TIP example This page walks through a complete H-only ...
5.3.3 Entering H-only cut values and reading output
Entering H-only cut values and reading output 5.3.3 oval method Once your Oval Cut Directi...
5.3.2 When to use H-only mode and which drill presses it suits
When to use H-only mode and which drill presses it suits 5.3.2 oval method H-only mode in ...
5.3.1 Setting up: Oval Cut Direction = H in Settings
Setting up: Oval Cut Direction = H in Settings 5.3.1 CALC oval method Before using the O...
5.2.8 Worked example: full V/H oval from start to finish
Worked example: full V/H oval from start to finish 5.2.8 TIP example This page walks thr...
5.2.7 Confirming cuts using the arrow-down key
Confirming cuts using the arrow-down key 5.2.7 oval method After entering V and H cut valu...
5.2.6 Entering V and H cut values (positive and negative)
Entering V and H cut values (positive and negative) 5.2.6 oval method When recording oval ...
5.2.5 Adding oval cut rows using the + button
Adding oval cut rows using the + button 5.2.5 oval method The Oval Calculator in Spectre C...
5.2.4 Reading the DIFF (decimal difference) auto-calculation
Reading the DIFF (decimal difference) auto-calculation 5.2.4 oval method Whenever you ente...