4.5 — Thumb Measurements (Oval)
4.5.1 Selecting "Oval" thumb hole on the spec sheet
Selecting "Oval" thumb hole on the spec sheet 4.5.1 KEY oval Drilling an oval thumb h...
4.5.2 Entering Starting Bit, Oval Width, Oval Degree, and Taper
Entering Starting Bit, Oval Width, Oval Degree, and Taper 4.5.2 oval TODO — write this page.
4.5.3 How the system calculates the oval cut from your inputs
How the system calculates the oval cut from your inputs 4.5.3 oval Once the four oval inpu...
4.5.4 Entering thumb oval span and pitch information
Entering thumb oval span and pitch information 4.5.4 oval For most spec sheets, span is me...