Advanced Search
Search Results
5 total results found
2.3.1 Default Hole Type — Round vs. Oval
2.3.1 KEY setting The Default Hole Type setting controls which hole type is pre-selected when you start a new spec sheet. Spectre Cloud supports two options: Round and Oval. Like all system defaults, this setting simply pre-populates the field — it can al...
2.3.2 Initial pitch inside the total oval — Edge vs. Center & Pitch Included Yes/No
2.3.2 oval When drilling an oval hole, Spectre Cloud needs a reference point from which to calculate the initial pitch of that hole. Because an oval opening has width — unlike a round hole, which has a single center point — there are two valid ways to defin...
2.3.3 Oval Width Calculator — Bit Size, Decimal, or Difference input method
2.3.3 oval When calculating an oval thumb hole, Spectre Cloud needs to know the oval width — the final size of the opening the bowler's thumb will sit in. This setting controls how you input that measurement. There are three options: Oval Width (Bit Size), ...
2.3.5 Oval Cut 'Move' Direction — V/H, H only, V only, or None
2.3.5 oval The Oval Cut Move Direction setting controls which directional components Spectre Cloud calculates and displays when outputting oval cut values. Depending on your drill press type and how you cut ovals, you may work with both vertical and horizon...
2.3.6 Flip V/H on oval cuts — matching your drill press DRO display order
2.3.6 oval The Flip V/H on oval cuts setting controls the display order of the vertical and horizontal values in the oval cut cards shown by the Spectre Cloud oval calculator. This setting should match the order your drill press digital readout (DRO) displa...