Advanced Search
Search Results
9 total results found
4.5.2 Entering Starting Bit, Oval Width, Oval Degree, and Taper
Entering Starting Bit, Oval Width, Oval Degree, and Taper 4.5.2 oval TODO — write this page.
4.5.1 Selecting "Oval" thumb hole on the spec sheet
Selecting "Oval" thumb hole on the spec sheet 4.5.1 KEY oval Drilling an oval thumb hole requires more setup information than a round hole. In addition to the standard thumb measurements, Spectre Cloud needs four oval-specific inputs to generate th...
4.5.3 How the system calculates the oval cut from your inputs
How the system calculates the oval cut from your inputs 4.5.3 oval Once the four oval inputs — starting bit, oval width, oval degrees, and taper — have been entered into the spec sheet, Spectre Cloud calculates the drilling instructions needed to produc...
4.5.4 Entering thumb oval span and pitch information
Entering thumb oval span and pitch information 4.5.4 oval For most spec sheets, span is measured and entered the same way regardless of thumb hole shape. Oval thumb holes introduce one specific scenario where the entered span requires an adjustment — wh...
2.3.2 Initial pitch inside the total oval — Edge vs. Center & Pitch Included Yes/No
2.3.2 oval When drilling an oval hole, Spectre Cloud needs a reference point from which to calculate the initial pitch of that hole. Because an oval opening has width — unlike a round hole, which has a single center point — there are two valid ways to defin...
2.3.3 Oval Width Calculator — Bit Size, Decimal, or Difference input method
2.3.3 oval When calculating an oval thumb hole, Spectre Cloud needs to know the oval width — the final size of the opening the bowler's thumb will sit in. This setting controls how you input that measurement. There are three options: Oval Width (Bit Size), ...
2.3.5 Oval Cut 'Move' Direction — V/H, H only, V only, or None
2.3.5 oval The Oval Cut Move Direction setting controls which directional components Spectre Cloud calculates and displays when outputting oval cut values. Depending on your drill press type and how you cut ovals, you may work with both vertical and horizon...
2.3.6 Flip V/H on oval cuts — matching your drill press DRO display order
2.3.6 oval The Flip V/H on oval cuts setting controls the display order of the vertical and horizontal values in the oval cut cards shown by the Spectre Cloud oval calculator. This setting should match the order your drill press digital readout (DRO) displa...
4.3.5 How to input a finger oval measurement (no inserts)
How to input a finger oval measurement (no inserts) For bowlers who do not use finger inserts, the oval measurement captures the natural shape of each finger hole needed to achieve a comfortable, secure fit. Because fingers ar...