Step-by-step guide

Following these steps will ensure a proper fit

1. Warm up the hand, massage/bowl
2. Measure the MIDDLE FINGER
3. Measure the THUMB FLEXIBILITY
4. Measure FINGER and THUMB hole sizes
   

---

Constants to fill out on the spec sheet

• Before starting the measurement, you can already write down some data on your spec sheet.
  1. Bowler Hand (Left or Right)
  2. Bridge of 3/8
  3. Lateral Pitches of 1/4 (middle) and 5/8 (ring)
  4. Ring Finger measurement will always be +1/8 from the span measured on the next step.

---

---

Mark the bowler's hand with a pen

1. Mark the MIDDLE FINGER
   • Find and mark the bending point of the SECOND joint.
   • Measure 3/8 under the joint, draw a line.
   • Use this line for your measurement.
     

---

Using the fitting tools

• BT Ball Fitter
• Innovative Fitting Ball

---

Evaluate the flexibility of the thumb.

The bowler's hand must be relaxed. 

• Pull back on the thumb to measure flexibility.
• Follow the chart provided for the correct pitch based on span/flexibility

give a link to the chart ??

show where to input in Spectre

---

Complete your Fitting Sheet

• Finger Pitches

Use the same pitches as what's in the thumb.

Ex: Span 3 ^1/2,  flexibility 120° = 3/8 forward

• Hole Sizes

- Select a hole size that... Fingers easily passes through up to but not including second joint             même chose pour le pouce ?

Not sure ?   When in doubt, reduce the hole by 1-64 inch. You can always enlarge the holes.