Skip to main content

4.6.2 Entering the oval inputs (step-by-step)

4.6.2   oval

This page is the step-by-step companion to 4.6.1. The four oval inputs — starting bit, oval width, oval degree, and taper — are defined in 4.6.1, and the calculation that turns them into drilling movements is covered in 4.6.3 and the Oval Calculator (Book 05).

  1. Set the thumb shape to Oval (4.5.1).
  2. Enter the starting bit diameter.
  3. Enter the oval width (finished width, including clearance).
  4. Enter the oval degree (orientation of the width axis).
  5. Enter the taper.
  6. Confirm all four values, then review the calculated oval cut (4.6.3) before drilling.
  • 4.6.1 — The four oval inputs, defined
  • 4.6.3 — How the system calculates the oval cut
  • 05 — Oval Calculator

Tip: Print or display the spec sheet at the press before you start — having the four inputs and the calculated output visible throughout the cut prevents errors from misremembering a value mid-drill.

Back to top